Útil alineado generador 7,5 Tn

Tool for the controlled lifting and horizontal alignment of the generator relative to the gearbox on wind turbines. Each unit combines a hydraulic cylinder, which lifts the generator to relieve the load on its silent blocks, and an M30 push screw with a swivel head, which moves it horizontally without marking its surfaces. The cylinder rod carries a nylon sliding pad that allows the generator to slide during alignment. The tool rests on the nacelle frame and is secured to it by adjustable clamps on threaded studs, suitable for frames from 260 to 400 mm wide. It is used as a set of four units, one under each generator support, ensuring even and stable lifting. Manufactured in S275 steel, CE-marked.